Lenze 9400 Manual de usuario descargar pdf (Pagina 98)

4 Drive interface

4.3 Device states

98

Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

Display parameters for diagnostic purposes

•In C00183

the current device state is shown.

•In C00150

(status word 1) the current device state is shown in a bit coded manner via

bits 8 ... 11:

• C02530

displays the active function state.

LED status displays

The control of the two LEDs "DRIVE READY" and "DRIVE ERROR" in the middle of the controller's front

panel depends on the device state. LED status displays for the device state

( 599)

Bit 11 Bit 10 Bit 9 Bit 8 Meaning

0000"Initialisation active" state

0001"Device is ready to switch on" state

0010-

0011"Device is switched on" state

0100-

0101-

0110"Operation" state

0111"Trouble active" state

1000-

1001-

1010"Quick stop by trouble active" state

1011"Safe torque off active" state

Observe LED on the safety module!

1100"Fault active" state

1101-

1110-

1111-

xxxxDisplayed message "Warning active"

or "Warning locked active"

The displayed message can occur at the same time as the device

states "Device is ready to switch on", "Device is switched on" and

"Operation", if a monitoring component responds for which the error

response "Warning" has been parameterised.

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 953 954

Comentarios a estos manuales

Sin comentarios