Lenze 9400 Manual de usuario descargar pdf (Pagina 423)

Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06 423

11 Basic drive functions

11.6 Homing

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

11.6.2.3 Home position & target position

When the home position is set during the reference search, the position detected in the machine

measuring system corresponds to the value set in C02642

.

For software versions lower than V4.0 the following applies:

• Afterwards the drive travels to the target position set in C02643

.

The following applies from software version V4.0:

• The subsequent drive behaviour is determined by the mode parameterised in C02641

. See the

below chapter "Drive behaviour after setting the home position

".

11.6.2.4 Drive behaviour after setting the home position

This function extension is available from software version V4.0!

C02641

can be used to select the drive behaviour after setting the home position.

Selection "0: Move absolute on Target position"

After setting the home position (C02642

), the drive moves to the absolute target position set in

C02643

.

This selection is the Lenze setting and corresponds to the behaviour known from the previous

versions.

Selection "1: Move relative by Target position"

After setting the home position (C02642

), the drive moves relatively by the target position set in

C02643

.

Selection "2: Stop immediately"

After setting the home position (C02642

), the drive stops immediately.

1 2 ... 418 419 420 421 422 423 424 425 426 427 428 ... 953 954

Comentarios a estos manuales

Sin comentarios