Lenze 9400 Manual de usuario descargar pdf (Pagina 654)

13 Diagnostics & fault analysis

13.7 Error messages of the operating system

654

Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

Resolver: Calculated acceleration unrealistic [0x007b001f]

Motor: Actual speed value > C00596 [0x007b0020]

Brake transistor: Overcurrent [0x007b0021]

Position encoder: Module selected in C00490 not available [0x007b0023]

Motor encoder: Module selected in C00495 not available [0x007b0024]

Module ID (decimal) Error ID (decimal)

123: Motor control 31

Response (Lenze setting printed in bold)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

Resolver evaluation faulty (implausible acceleration at

the resolver).

Check structure.

Module ID (decimal) Error ID (decimal)

123: Motor control 32

Response (Lenze setting printed in bold) Setting: C00607 ( Adjustable response)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

Threshold for speed monitoring set in C00596 has been

exceeded.

Check drive dimensioning.

Module ID (decimal) Error ID (decimal)

123: Motor control 33

Response (Lenze setting printed in bold)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

Brake chopper short circuit/earth fault detected. Check brake chopper cable and brake resistor.

Module ID (decimal) Error ID (decimal)

123: Motor control 35

Response (Lenze setting printed in bold)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

The position encode selected under C00490 has not been

recognised.

• Check position encoder.

• Check parameter setting (C00490

).

Module ID (decimal) Error ID (decimal)

123: Motor control 36

Response (Lenze setting printed in bold)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

The motor encoder selected under C00495 has not been

recognised.

• Check motor encoder.

• Check parameter setting (C00495

).

1 2 ... 649 650 651 652 653 654 655 656 657 658 659 ... 953 954

Comentarios a estos manuales

Sin comentarios