Lenze 9400 Manual de usuario descargar pdf (Pagina 709)

Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06 709

13 Diagnostics & fault analysis

13.7 Error messages of the operating system

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

Int. overflow C02713 (max. dist. manual control) [0x00b8002c]

Int. overflow C02642 (home position) [0x00b8002d]

Int. overflow C02643 (homing: Target position) [0x00b8002e]

Module ID (decimal) Error ID (decimal)

184: Basic drive functions 44

Response (Lenze setting printed in bold)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

From software version V3.0

Due to a subsequent change of the machine parameters

for gearbox ratio, feed constant, or resolution of an

encoder revolution, the value set in the parameter

cannot be displayed in the internal unit. See chapter

"Max. position, speed, and acceleration that can be

displayed internally".

• Check machine parameters and adapt them if

required.

• Change setting in C02713

.

Module ID (decimal) Error ID (decimal)

184: Basic drive functions 45

Response (Lenze setting printed in bold)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

From software version V3.0

Due to a subsequent change of the machine parameters

for gearbox ratio, feed constant, or resolution of an

encoder revolution, the value set in the parameter

cannot be displayed in the internal unit. See chapter

"Max. position, speed, and acceleration that can be

displayed internally".

• Check machine parameters and adapt them if

required.

• Change setting in C02642

.

Module ID (decimal) Error ID (decimal)

184: Basic drive functions 46

Response (Lenze setting printed in bold)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

From software version V3.0

Due to a subsequent change of the machine parameters

for gearbox ratio, feed constant, or resolution of an

encoder revolution, the value set in the parameter

cannot be displayed in the internal unit. See chapter

"Max. position, speed, and acceleration that can be

displayed internally".

• Check machine parameters and adapt them if

required.

• Change setting in C02643

.

1 2 ... 704 705 706 707 708 709 710 711 712 713 714 ... 953 954

Comentarios a estos manuales

Sin comentarios