Lenze 9400 Manual de usuario descargar pdf (Pagina 676)

13 Diagnostics & fault analysis

13.7 Error messages of the operating system

676

Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

Lenze setting loaded [0x00900001]

Parameter set saved [0x00900002]

Parameter set loaded [0x00900003]

Loading of Lenze setting failed [0x00900004]

Parameter set restored [0x00900005]

Module ID (decimal) Error ID (decimal)

144: Parameter manager 1

Response (Lenze setting printed in bold)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

Lenze setting has been loaded. - (Information only)

Module ID (decimal) Error ID (decimal)

144: Parameter manager 2

Response (Lenze setting printed in bold)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

Parameter set has been saved. - (Information only)

Module ID (decimal) Error ID (decimal)

144: Parameter manager 3

Response (Lenze setting printed in bold)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

Parameter set has been loaded. - (Information only)

Module ID (decimal) Error ID (decimal)

144: Parameter manager 4

Response (Lenze setting printed in bold)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

Lenze setting of a parameter is not within the valid

limits.

Eliminate error in the application and retransfer

application to controller.

Module ID (decimal) Error ID (decimal)

144: Parameter manager 5

Response (Lenze setting printed in bold)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

An error has occurred while loading the selected

parameter set.

Transfer parameter set from Engineer to the controller

and save with C00002

="11".

1 2 ... 671 672 673 674 675 676 677 678 679 680 681 ... 953 954

Comentarios a estos manuales

Sin comentarios