Lenze 9400 Manual de usuario descargar pdf (Pagina 659)

Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06 659

13 Diagnostics & fault analysis

13.7 Error messages of the operating system

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

Electronic nameplate: Data outside the parameter limits [0x007b0039]

Hiperface encoder: Transmission error [0x007b003a]

Hiperface encoder: Command error [0x007b003b]

Module ID (decimal) Error ID (decimal)

123: Motor control 57

Response (Lenze setting printed in bold)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

The motor parameters of the electronic nameplate are

outside of the limit values of the controller and therefore

cannot be accepted.

Consultation with Lenze required.

Module ID (decimal) Error ID (decimal)

123: Motor control 58

Response (Lenze setting printed in bold)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

• Encoder signal interferences (EMC).

• Encoder cable interrupted.

• Encoder defective.

• Faulty parameter setting of the encoder.

Note: This information is always supplied together with

the "I/O error - encoder communication" error message

and is entered in the logbook even if the encoder

monitoring is deactivated (C00580

).

• Check encoder cable, use shorter encoder cable if

required.

•Check encoder.

• Check parameter setting (C00420

, C00421, C00422).

Module ID (decimal) Error ID (decimal)

123: Motor control 59

Response (Lenze setting printed in bold)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

• Encoder signal interferences (EMC).

• Encoder cable interrupted.

• Encoder defective.

• Faulty parameter setting of the encoder.

Note: This information is always supplied together with

the "I/O error - encoder communication" error message

and is entered in the logbook even if the encoder

monitoring is deactivated (C00580

).

• Check encoder cable, use shorter encoder cable if

required.

•Check encoder.

• Check parameter setting (C00420

, C00421, C00422).

1 2 ... 654 655 656 657 658 659 660 661 662 663 664 ... 953 954

Comentarios a estos manuales

Sin comentarios