Lenze 9400 Manual de usuario descargar pdf (Pagina 720)

14 Parameter reference

14.2 Parameter list

720

Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

14.2 Parameter list

This chapter lists all parameters of the operating system in numerically ascending order.

C00002

 Note!

The parameter descriptions are based on the software version V12.00.xx.

Parameter | Name:

C00002 | Device command

Data type: UNSIGNED_32

Index: 24573

d

= 5FFD

h

Device commands

• C00003

shows the status of the last executed device command.

•Under C00150

you can query the current status of the device control.

Note:

Before switching off the supply voltage after a device command has been executed, check the successful execution

of the device command via the status display in C00003

!

The meaning of the status display in C00003

can be obtained from the subchapter for the corresponding device

command in chapter "Device commands

".

Selection list (Lenze setting printed in bold) Info

0 Load Lenze setting Resets parameters to Lenze setting.

• Only possible when the application has stopped and

the controller is inhibited.

1 Load start parameters Loads parameters from the memory module.

• Only possible when the application has stopped and

the controller is inhibited.

2 ENP: Load plant data Reads plant data from the electronic motor nameplate.

• Only possible when the application has stopped and

the controller is inhibited.

5 Activate application Activates the application selected under C00005

.

• Whether the application is also started, depends on

the auto-start setting selected.

• Only possible when the application has stopped.

7 Save selected application Selects the active application as start application.

11 Save start parameters Saves parameters fail-safe in the memory module.

20 Delete logbook Deletes all logbook entries.

21 Archive logbook Exports logbook entries to file.

27 Device search function ON

28 Device search function OFF

31 Start application

32 Stop application

33 Reset program Carries out a reset.

• All variables are reset to their initialisation value.

• The situation corresponds to the start of a new

program loaded into the control (cold start).

34 Delete program Carries out a reset (source).

• All variables are reset to their initialisation value.

• The application program is deleted and the controller

is reset to its original state.

1 2 ... 715 716 717 718 719 720 721 722 723 724 725 ... 953 954

Comentarios a estos manuales

Sin comentarios