Lenze 9400 Manual de usuario descargar pdf (Pagina 372)

11 Basic drive functions

372 Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

11 Basic drive functions

In this chapter the basic (drive) functions of the "Servo Drives 9400" are described, to which the

active application can access via defined, internal interfaces, and which can be carried out in the

following way, depending on the controller type (StateLine or HighLine) and the Motion Control

licence available:

Parameter setting by means of »Engineer« or keypad

In each licence level the basic functions can be parameterised in »Engineer« via a

corresponding dialog or alternatively via the keypad.

In the case of the 9400 StateLine (licence level Motion Control StateLevel), the

interconnection of the internal interfaces is defined by the technology application

selected.

Configuration in the »Engineer« function block editor

»Engineer« additionally provides the graphic function block editor for the 9400

HighLine which can be used to reconfigure and extend the application

interconnection by individual functions using the function library.

Programming according to IEC 61131-3 in »PLC Designer«*

For the 9400 HighLine with the licence level Motion Control PLC the basic functions

are also provided as separate system blocks in »PLC Designer«, which, if required,

can be integrated in the control configuration, and which then can be accessed from

the IEC 61131-3 program via the corresponding system variables.

* In preparation!

1 2 ... 367 368 369 370 371 372 373 374 375 376 377 ... 953 954

Comentarios a estos manuales

Sin comentarios