Lenze 9400 Manual de usuario descargar pdf (Pagina 710)

13 Diagnostics & fault analysis

13.7 Error messages of the operating system

710

Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

Int. overflow C02644 (homing: Speed 1) [0x00b8002f]

Int. overflow C02645 (homing: Acceleration 1) [0x00b80030]

Int. overflow C02646 (homing: Speed 2) [0x00b80031]

Module ID (decimal) Error ID (decimal)

184: Basic drive functions 47

Response (Lenze setting printed in bold)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

From software version V3.0

Due to a subsequent change of the machine parameters

for gearbox ratio, feed constant, or resolution of an

encoder revolution, the value set in the parameter

cannot be displayed in the internal unit. See chapter

"Max. position, speed, and acceleration that can be

displayed internally".

• Check machine parameters and adapt them if

required.

• Change setting in C02644

.

Module ID (decimal) Error ID (decimal)

184: Basic drive functions 48

Response (Lenze setting printed in bold)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

From software version V3.0

Due to a subsequent change of the machine parameters

for gearbox ratio, feed constant, or resolution of an

encoder revolution, the value set in the parameter

cannot be displayed in the internal unit. See chapter

"Max. position, speed, and acceleration that can be

displayed internally".

• Check machine parameters and adapt them if

required.

• Change setting in C02645

.

Module ID (decimal) Error ID (decimal)

184: Basic drive functions 49

Response (Lenze setting printed in bold)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

From software version V3.0

Due to a subsequent change of the machine parameters

for gearbox ratio, feed constant, or resolution of an

encoder revolution, the value set in the parameter

cannot be displayed in the internal unit. See chapter

"Max. position, speed, and acceleration that can be

displayed internally".

• Check machine parameters and adapt them if

required.

• Change setting in C02646

.

1 2 ... 705 706 707 708 709 710 711 712 713 714 715 ... 953 954

Comentarios a estos manuales

Sin comentarios