Lenze 9400 Manual de usuario descargar pdf (Pagina 657)

Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06 657

13 Diagnostics & fault analysis

13.7 Error messages of the operating system

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

Failure of motor phase W [0x007b002f]

Electronic nameplate: Data loaded [0x007b0030]

Electronic nameplate: Not found [0x007b0031]

Electronic nameplate: Encoder protocol unknown [0x007b0032]

Electronic nameplate: Encoder signal unknown [0x007b0033]

Module ID (decimal) Error ID (decimal)

123: Motor control 47

Response (Lenze setting printed in bold) Setting: C00597 ( Adjustable response)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

W phase interruption of the motor cable. • Check cabling between the controller and motor.

• Check parameter setting (C00599

).

Module ID (decimal) Error ID (decimal)

123: Motor control 48

Response (Lenze setting printed in bold)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

New electronic nameplate (ENP) has been found. - (Information only)

Module ID (decimal) Error ID (decimal)

123: Motor control 49

Response (Lenze setting printed in bold)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

Electronic nameplate (ENP) is not available. - (Information only)

Module ID (decimal) Error ID (decimal)

123: Motor control 50

Response (Lenze setting printed in bold)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

The connected motor with feedback is not supported by

the controller firmware.

Check drive dimensioning.

Module ID (decimal) Error ID (decimal)

123: Motor control 51

Response (Lenze setting printed in bold)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

The connected motor with feedback is not supported by

the controller firmware.

Check drive dimensioning.

1 2 ... 652 653 654 655 656 657 658 659 660 661 662 ... 953 954

Comentarios a estos manuales

Sin comentarios