Lenze 9400 Manual de usuario descargar pdf (Pagina 708)

13 Diagnostics & fault analysis

13.7 Error messages of the operating system

708

Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

Int. overflow C02708/2 (decel. limited speed 2) [0x00b80029]

Int. overflow C02708/3 (decel.limited speed 3) [0x00b8002a]

Int. overflow C02708/4 (decel. limited speed 4) [0x00b8002b]

Module ID (decimal) Error ID (decimal)

184: Basic drive functions 41

Response (Lenze setting printed in bold)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

From software version V3.0

Due to a subsequent change of the machine parameters

for gearbox ratio, feed constant, or resolution of an

encoder revolution, the value set in the parameter

cannot be displayed in the internal unit. See chapter

"Max. position, speed, and acceleration that can be

displayed internally".

• Check machine parameters and adapt them if

required.

• Change setting in C02710/2

.

Module ID (decimal) Error ID (decimal)

184: Basic drive functions 42

Response (Lenze setting printed in bold)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

From software version V3.0

Due to a subsequent change of the machine parameters

for gearbox ratio, feed constant, or resolution of an

encoder revolution, the value set in the parameter

cannot be displayed in the internal unit. See chapter

"Max. position, speed, and acceleration that can be

displayed internally".

• Check machine parameters and adapt them if

required.

• Change setting in C02710/3

.

Module ID (decimal) Error ID (decimal)

184: Basic drive functions 43

Response (Lenze setting printed in bold)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

From software version V3.0

Due to a subsequent change of the machine parameters

for gearbox ratio, feed constant, or resolution of an

encoder revolution, the value set in the parameter

cannot be displayed in the internal unit. See chapter

"Max. position, speed, and acceleration that can be

displayed internally".

• Check machine parameters and adapt them if

required.

• Change setting in C02710/4

.

1 2 ... 703 704 705 706 707 708 709 710 711 712 713 ... 953 954

Comentarios a estos manuales

Sin comentarios