Lenze 9400 Manual de usuario descargar pdf (Pagina 113)

Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06 113

4 Drive interface

4.7 Internal interfaces | "LS_DriveInterface" system block

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

4.7.1 Status signals

The following representation shows which status signals of the drive interface are set to TRUE in

different typical cases:

Case 1:

Application has been transmitted to the controller.

No mains voltage available (LU fault).

Controller is inhibited (via RFR terminal).

Case 2:

Mains voltage has been connected.

Case 3:

Controller inhibit has been deactivated.

Case 4:

Fault active.

Case 5:

Quick stop by trouble is active

Status Status signal (output)

Ready for operation

  DI_bReady

Fault active

  DI_bFailActive

Pulse inhibit active

   DI_bImpActive

Controller inhibit active

   DI_bCInhActive

Warning active

DI_bWarningActive

Undervoltage detected

 DI_bUVDetected

Overvoltage detected

DI_bOVDetected

Mains supply is ok

    DI_bMainSupplyOk

Ready to switch on

DI_bReadyToSwitchOn

Operation enabled

 DI_bOperationEnabled

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 953 954

Comentarios a estos manuales

Sin comentarios