Lenze 9400 Manual de usuario descargar pdf (Pagina 561)

Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06 561

11 Basic drive functions

11.13 Cam data management

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

11.13.3.1 Password entry

If a password has been defined for the cam data in »Engineer«, the defined user password must be

entered once to execute the following actions:

• Download of new cam data during operation

 Entry of the existing password in »Engineer«.

• Change of the cam data via parameter setting

 Entry of the existing password in C02900

.

• Loading/saving of the cam data

 entry of the existing password in C02900

.

 Tip!

The access protection for the cam data can be configured on the Online tab. "Online" tab

for cam data management ( 553)

Validity

The user password entered in C02900

is maintained until the next download, mains switching, or

until reset by the user (logout).

• You can "log out" deliberately by entering an invalid password into C02900

.

Behaviour in case of invalid entry

If the user password is entered incorrectly three times, the cam data are blocked. A correct entry

resets the number of the failed attempts.

To remove the blocking of the cam data, there are two possibilities:

A. Resetting the parameters to the Lenze setting via device command C00002

= "0: Load Lenze

setting".

• When the Lenze setting is loaded, the cam data are deleted.

• Afterwards the cam data can be transferred to the device again.

B. Transfer complete application to the device again.

• The application available and the cam data are deleted and all data are transferred to the

device again.

 Note!

From software version V4.0 onwards, you do not need to enter a possibly existing user

password (C02900

) if you want to save the cam data.

1 2 ... 556 557 558 559 560 561 562 563 564 565 566 ... 953 954

Comentarios a estos manuales

Sin comentarios