Lenze 9400 Manual de usuario descargar pdf (Pagina 149)

Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06 149

5 Motor interface

5.4 Servo control (SC)

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

Setting of actual speed filter

In order to maximise the dynamics of the speed control loop, the actual speed filter should be

operated with a time constant as low as possible (C00497

). The lower the time constant the higher

the gain of the speed controller. Since actual value filters have the task to dampen measuring errors

or interference components, it must be found a compromise between filter task and the resulting

delay.

If a Lenze motor is selected from the motor catalogue, a time constant is automatically preset in

C00497

which serves to operate the motor even with a faulty detection (e.g. in case of a bad shield

connection).

When using EMC-compliant systems or high-quality encoders, you can reduce the preset time

constant considerably. For this purpose, the running noise of the motor can be used for setting

C00497

at constant speed.

If this is not possible, e.g. due to a too loud environment or because the motor is too far away, the

noise of the actual speed value or the setpoint torque value can be used for evaluation by means of

the Oscilloscope

. Please observe that the speed controller gain Vp (C00070) in is used for the torque

setpoint.

Dynamics of the actual value detection

Another element which influences the maximally achievable control dynamics, is the dynamics of

the actual value detection itself. In case of optical encoders, the time delay by the actual value

detection does not need to be considered. This does not apply to resolvers.

The resolver evaluation of the controller is adapted to the resolver types mounted in Lenze motors

and offers a good compromise between the dynamic performance and interference suppression. If

the resolver is used as a speed feedback system, the dynamic performance of the resolver evaluation

determines, among other things, the maximum speed controller gain by means of which stable

operation is possible.

From software version V5.0 onwards, it is possible to increase the dynamics of the resolver

evaluation in C00417

in an EMC-compliant system (with low interference) without a quality loss in

the speed signal.

Adaptation of the resolver evaluation dynamics

( 250)

1 2 ... 144 145 146 147 148 149 150 151 152 153 154 ... 953 954

Comentarios a estos manuales

Sin comentarios