Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37 Manual de usuario Pagina 574

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 679
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 573
9400 HighLine | Parameter setting & configuration
Parameter reference
Parameter list | C00356
574 Firmware 1.37 - 09/2006 L
C00356
C00357
C00359
Parameter | Name:
C00356 | CAN TPDOx cycle time
Data type: UNSIGNED_16
Index: 24219
d
= 5E9B
h
TPDO event time from DS301V402.
With a value unequal "0", the TPDO will be sent after the set time without considering the transmission type.
Setting range
(min. value | unit | max. value)
0 ms 65535
Subcodes Lenze setting Information
C00356/1 0 ms Cycle time for TPDO1 ... TPDO4
C00356/...
C00356/4
; Read access ; Write access CINH PLC STOP No transfer COM MOT
Parameter | Name:
C00357 | CAN RPDOx monitoring time
Data type: UNSIGNED_16
Index: 24218
d
= 5E9A
h
RPDO event time from DS301V402.
With a value unequal "0", the RPDO will be expected after the set time.
If the RPDO is not received within this time, a parameterisable error message can be activated.
Setting range
(min. value | unit | max. value)
0 ms 65535
Subcodes Lenze setting Information
C00357/1 3000 ms Monitoring time for RPDO1 ... RPDO4
C00357/...
C00357/4
; Read access ; Write access CINH PLC STOP No transfer COM MOT
Parameter | Name:
C00359 | CAN status
Data type: UNSIGNED_8
Index: 24216
d
= 5E98
h
Selection list (display only)
0Operational
1 Pre-operational
4Boot up
5 Stopped
7 Reset
8 INITIALISATION
9Unknown
10 Autom. baud rate detection active
; Read access Write access CINH PLC STOP No transfer COM MOT
Vista de pagina 573
1 2 ... 569 570 571 572 573 574 575 576 577 578 579 ... 678 679

Comentarios a estos manuales

Sin comentarios