
L Firmware 1.37 - 09/2006 277
9400 HighLine | Parameter setting & configuration
Standard TAs
TA "Actuator – torque" | Torque follower
11.3.6 Torque follower
[11-20] Basic function "Torque follower" (schematic diagram)
The torque-controlled operation is requested via the digital input DI2. If no other basic
function and error state are active, the torque-controlled operation is enabled.
r The build-up of the defined torque is controlled via a ramp generator based on the
current torque.
r Based on the current motor speed the internal speed limit value is also led to the
setpoint via a ramp generator after the operation is enabled.
r If the enable of the torque-controlled operation is reset via the digital input DI2, the
drive is decelerated to standstill via an independent profile generator of the basic
function "Stop". Standard stop
(C 148)
O Tip!
Detailed information on the torque follower can be found in the chapter "basic
drive functions" subchapter "Torque follower
". (C 196)
Offset
M
LS_ManualJog
n
t
è
ç
LS_Brake
n
t
LS_Limiter
n
t
LS_Quickstop
STOP
Gain Invert setpoint
Selection
LS_Torque...
M
Torque
setpoint
n
t
LS_Stop
internal
status machine
DI2
DI6
DI7
DI8
DI1DI3
DI4
OUT
IN
Ramp generator
%1
%2
%15
Fixed setpoints
OUT
IN
Ramp generator
Status
machine
(basic drive
functions)
Torque setpoint Basic drive functions
Speed limit
AIN1
AIN2
v
F
è
ç
Comentarios a estos manuales