Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37 Manual de usuario Pagina 373

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 679
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 372
L Firmware 1.37 - 09/2006 373
9400 HighLine | Parameter setting & configuration
TAs for positioning tasks
TA "Multi-purpose positioning" | Assignment of the I/O terminals
13.2.2 Assignment of the I/O terminals
13.2.2.1 Setpoint and control signals
The following tables contain the Lenze assignment of the analog and digital inputs for the
technology application "Multi-purpose positioning".
Analog inputs
Digital inputs
Terminal X3 Signal (Lenze setting)
AI1-
AI1+
Selection for speed override
Speed/acceleration override
(C 399)
AI2-
AI2+
Selection for acceleration override
Speed/acceleration override
(C 399)
I/O terminalsAnalog inputs (C 117)
Terminal X5 Signal (Lenze setting)
DI1 Quick stop
If DI1 is set to LOW level, the positioning program is interrupted and drive is decelerated
to standstill within the deceleration time set for the quick stop function independent of
the setpoint selection.
After the quick stop function is deactivated, a new LOW/HIGH edge is required at DI6 in
order that the positioning program is continued with the next step.
Quick stop
(C 402)
DI2 Connection of reference switch/touch probe sensor
Action type "Homing"
(C 382)
DI3
DI4
Connection of travel range limit switch for basic function "Limiter
". (C 403)
DI3 = positive travel range limit switch, DI4 = negative travel range limit switch.
The inputs respond to the FALSE state (fail-safe).
DI5 Reset error and positioning program
By means of a LOW-HIGH edge an existing error status can be reset if the cause of the
fault is removed. At the same time the positioning program is reset.
DI6 Start positioning program
Control of the sequence table
(C 389)
DI7 Stop positioning program (break)
Control of the sequence table
(C 389)
DI8 Sequencer input 8 for positioning program
The action types "Positioning", Branching", "Waiting" and "Stand-by" have the parameter
"Input for...". If this is non-zero, it describes the number of the sequencer input where the
positioning program awaits the level defined before it executes the action. In the Lenze
assignment the terminal DI8 is available as sequencer input 8.
Program flow
(C 378)
I/O terminalsDigital inputs (C 123)
A1+
A1-
A1-
A1R
A2+
A2-
GI
RFR
DI1
DI2
DI3
DI4
DI5
DI6
DI7
DI8
Vista de pagina 372
1 2 ... 368 369 370 371 372 373 374 375 376 377 378 ... 678 679

Comentarios a estos manuales

Sin comentarios