Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37 Manual de usuario Pagina 166

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 679
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 165
9400 HighLine | Parameter setting & configuration
Basic drive functions
Homing | Parameter setting
166 Firmware 1.37 - 09/2006 L
r For reference setting, select the homing mode "100" in C02640.
r The homing modes "0"..."15", which are described in detail in the following sections, are
available for a reference search in C02640
.
Depending on the mode selected the following switches/sensors are evaluated:
Switch Input for digital input signal
Reference switch HM_bHomingMark on SB LS_Homing
Touch probe sensor DIGIN_bIn1 ... DIGIN_bIn8 (or optional use of the motor encoder or load
encoder zero pulse). Configuration: C02651
.
Positive travel range limit switch LIM_bLimitSwitchPositive on SB LS_Limiter
Negative travel range limit switch LIM_bLimitSwitchNegative on SB LS_Limiter
Note!
In the homing modes 0...5 as well as 10 and 11, the search for the limit switch/
reference switch is achieved by changing over to a higher speed than for
approaching the encoder zero pulse/touch probe sensor. This serves to reduce
the homing time and increase the accuracy.
After setting the home position the drive travels to the target position set in
C02643
.
Operation of mode 0:
1. Movement in positive direction.
2. Negative edge at HM_bHomingMark enables
home position detection.
3. The following positive edge of the encoder
zero pulse/touch probe sensor set the
reference.
Operation of mode 1:
1. Movement in negative direction.
2. Negative edge at HM_bHomingMark enables
home position detection.
3. The following positive edge of the encoder
zero pulse/touch probe sensor set the
reference.
bHomingMark
Reference position
Z-Impulse Encoder
bHomingMark
Reference position
Z-Impulse Encoder
Vista de pagina 165
1 2 ... 161 162 163 164 165 166 167 168 169 170 171 ... 678 679

Comentarios a estos manuales

Sin comentarios