
L Firmware 1.37 - 09/2006 495
9400 HighLine | Parameter setting & configuration
Diagnostics & error analysis
Error messages of the operating system
MXI1: CAN module missing or incompatible [0x008c0017]
MXI2: CAN module missing or incompatible [0x008c0018]
Connection table in use [0x008c001a]
Internal error (CRC application) [0x008c001d]
Parameter set faulty [0x00900000]
Lenze setting loaded [0x00900001]
Response (Lenze setting printed in bold)
None System fault : Fault Trouble Quick stop by trouble Warning locked Warning Information
Cause Remedy
The CANopen communication module in module
receptacle MXI1 is incompatible with the application.
Use communication module supported by the
application.
Response (Lenze setting printed in bold)
None System fault : Fault Trouble Quick stop by trouble Warning locked Warning Information
Cause Remedy
The CANopen communication module in module
receptacle MXI2 is incompatible with the application.
Use communication module supported by the
application.
Response (Lenze setting printed in bold)
None System fault Fault Trouble Quick stop by trouble Warning locked Warning : Information
Cause Remedy
This application is provided with a connection table
which means that connections can be changed online
without executing a completely new download.
- (Information only)
Response (Lenze setting printed in bold)
None System fault : Fault Trouble Quick stop by trouble Warning locked Warning Information
Cause Remedy
The checksum of the application is faulty. Retransmit the application to the controller.
Response (Lenze setting printed in bold)
None System fault : Fault Trouble Quick stop by trouble Warning locked Warning Information
Cause Remedy
Parameter set is invalid. Transfer parameter set from Engineer to the controller
and save with C00002
="11".
Response (Lenze setting printed in bold)
None System fault Fault Trouble Quick stop by trouble Warning locked Warning : Information
Cause Remedy
"Lenze setting has been loaded." - (Information only)
Comentarios a estos manuales