Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37 Manual de usuario Pagina 463

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 679
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 462
L Firmware 1.37 - 09/2006 463
9400 HighLine | Parameter setting & configuration
Diagnostics & error analysis
Error messages of the operating system
PLC configuration is invalid [0x00750006]
Heatsink: Temperature > C00122 [0x00770000]
Heatsink: Overtemperature [0x00770001]
Motor: Temperature > C00121 [0x00770002]
Motor: Overtemperature [0x00770003]
Response (Lenze setting printed in bold)
None System fault : Fault Trouble Quick stop by trouble Warning locked Warning Information
Cause Remedy
An invalid control configuration has occurred. Load other application.
Response (Lenze setting printed in bold) Setting: C00582 (; Adjustable response)
; None System fault ; Fault Trouble Quick stop by trouble Warning locked : Warning Information
Cause Remedy
Heatsink temperature higher than variable limit
temperature (C00122
).
Controller ambient temperature too high.
Dirty fan or ventilation slots.
Value set under C00122 is too low.
Check control cabinet temperature.
Clean filter.
Clean controller.
Set a higher value under C00122
.
Response (Lenze setting printed in bold)
None System fault : Fault Trouble Quick stop by trouble Warning locked Warning Information
Cause Remedy
Heatsink temperature higher than fixed limit
temperature (90 °C).
Controller ambient temperature too high.
Dirty fan or ventilation slots.
Check control cabinet temperature.
Clean filter.
Clean controller.
Response (Lenze setting printed in bold) Setting: C00584 (; Adjustable response)
; None System fault ; Fault Trouble Quick stop by trouble Warning locked : Warning Information
Cause Remedy
Motor temperature higher than variable limit
temperature (C00121
).
Motor too hot due to impermissibly high currents or
frequent and too long acceleration.
•No PTC connected.
Value set under C00121
is too low.
Check drive dimensioning.
Connect PTC or switch off monitoring (C00584
="3").
Set a higher value under C00121
.
Response (Lenze setting printed in bold) Setting: C00583 (; Adjustable response)
; None System fault : Fault Trouble Quick stop by trouble Warning locked ; Warning Information
Cause Remedy
Motor temperature higher than fixed limit temperature
(150 °C).
Motor too hot due to impermissibly high currents or
frequent and too long acceleration.
•No PTC connected.
Check drive dimensioning.
Connect PTC or switch off monitoring (C00584
="3").
Vista de pagina 462
1 2 ... 458 459 460 461 462 463 464 465 466 467 468 ... 678 679

Comentarios a estos manuales

Sin comentarios