Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37 Manual de usuario Pagina 423

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 679
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 422
L Firmware 1.37 - 09/2006 423
9400 HighLine | Parameter setting & configuration
Oscilloscope
Operation
Delay Delay between recording and trigger event.
Pre-trigger Select a negative delay time to detect signals prior to the trigger event.
In the oscillograph, the trigger time is designated by a dotted line.
With triggering on occurrence of an event, it is thus possible to detect the values that
have caused the event.
Post-trigger Select a positive delay time to detect signals occurring a certain time after the trigger event.
Edge If the trigger source is a channel or a variable, you can choose between the following trigger
modes:
Positive edge For triggering on a BOOL variable:
Trigger activation requires a FALSE-TRUE transition.
For triggering on a different variable:
For trigger activation, the selected trigger value must be exceeded.
Negative edge For triggering on a BOOL variable:
Trigger activation requires a TRUE-FALSE transition.
For triggering on a different variable:
For trigger activation, the selected trigger value must be fallen below.
Change For triggering on a BOOL variable:
Trigger activation requires a status change.
For triggering on a different variable:
For trigger activation, the current value must be different than the last value.
Setting Function
Trigger event
Trigger
delay
(negative)
Trigger level
Trigger event
Trigger
delay
(positive)
Trigger level
Vista de pagina 422
1 2 ... 418 419 420 421 422 423 424 425 426 427 428 ... 678 679

Comentarios a estos manuales

Sin comentarios