
L Firmware 1.37 - 09/2006 153
9400 HighLine | Parameter setting & configuration
Basic drive functions
Quick stop
Parameter setting of quick stop
[9-7] Deceleration time referred to the motor reference speed
[9-8] Deceleration time referred to the current speed
[9-9] S-shaped deceleration ramp through selection of a relative S-ramp time
O Tip!
After the drive has come to standstill, you can use the torque to hold the standstill
position.
• For this purpose, select the phase controller gain in C00254
>"0".
•With C00254
> "0" the phase control is automatically activated after the
standstill is reached.
r The deceleration time set in C00105
for the quick stop function refers to a
speed variation from the motor
reference speed (C00011
) to standstill.
n
t
C00011
C00105
TRUE
FALSE
bActivate1...3
t
r When C00107 is set = "1", the
deceleration time refers to the current
speed.
C00105
n
t
C00011
r Through the entry of a relative S-ramp
time in C00106
an S-shaped
deceleration ramp for jerk reduction
can be set. This prolongs the total time
to standstill by the selected S-ramp
time.
r Braking time at motor reference speed
or C00107
="1":
n
t
C00011
n
t
C00011
C00107 = 0
C00107 = 1
C00105 +
C00105 C00106×
100 %
C00105
C00105 C00106 [%]⋅
100 %
------------------------------------------------------+
Comentarios a estos manuales