Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37 Manual de usuario Pagina 171

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 679
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 170
L Firmware 1.37 - 09/2006 171
9400 HighLine | Parameter setting & configuration
Basic drive functions
Homing | Parameter setting
9.5.1.4 Homing to end stop
By selecting the homing modes 14 & 15, homing to end stop can be executed as follows:
1. The drive travels with reduced torque in positive direction (mode 14) or negative
direction (mode 15).
2. When the drives hits an end stop so that the torque limit set in C02649
is exceeded for
the period of time defined in C02650
, the reference is set.
When a reference offset is set, it is traversed by this offset with correct sign.
9.5.1.5 Connection of reference switch
For the homing modes with reference switch, the control input HM_bHomingMark of the
system block LS_Homing
must be connected to the digital input which is connected to the
reference switch.
9.5.1.6 Touch probe interface configuration
The touch probe channel to be used for homing with touch probe detection is selected in
the »Engineer« on the Application parameter tab in the overview dialog level. All basic
functions Homing TP interface.
r The setting carried out in this parameterisation dialog directly affects the setting of
C02651
("Ref. touch probe configuration") and vice versa.
r For a direct setting of C02651
(e.g. with keypad) the following table lists the decimal
values for all possible configurations.
r Example: For selecting the touch probe channel "DIGIN 8" and response to only one
positive edge, it is required to set the decimal value "16384" in C02651
.
Selection
Touch probe channel
Touch probe response
Positive edge Negative edge Both edges
DigIn 1 1 2 3
DigIn 2 4 8 12
DigIn 3 16 32 48
DigIn 4 64 128 192
DigIn 5 256 512 768
DigIn 6 1024 2048 3072
DigIn 7 4096 8192 12288
DigIn 8 16384 32768 49152
Motor encoder zero pulse 65536
Load encoder zero pulse 262144
Vista de pagina 170
1 2 ... 166 167 168 169 170 171 172 173 174 175 176 ... 678 679

Comentarios a estos manuales

Sin comentarios