
9400 HighLine | Parameter setting & configuration
Basic drive functions
Brake control | Parameter setting
212 Firmware 1.37 - 09/2006 L
9.11.1 Parameter setting
r Parameterisation dialog in the »Engineer«: Tab Application parameter dialog level
Overview All basic functions Brake control
r Short overview of parameters for brake control:
Danger!
For a faultless function of the automatic brake system the different delay times
must be set correctly in the following parameters!
If the delay times are set incorrectly, a faulty brake control may be caused!
Parameters Information
C02580
Operating mode - brake
C02581
Brake activation threshold
C02582
Brake resp. to pulse inhibit
C02583
Status input monitoring
C02585
Brake control polarity
C02586
Starting torque 1
C02587
Starting torque 2
C02588
Source of starting torque
C02589
Brake closing time
C02590
Brake opening time
C02591
Waiting time - status monit.
C02593
Waiting time - brake active.
C02594
Test torque
C02595
Permissible angle of rotation
C02596
Grinding speed
C02597
Accel./decel. time - grinding
C02598
Grinding ON time
C02599
Grinding OFF time
Comentarios a estos manuales