Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37 Manual de usuario Pagina 567

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 679
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 566
L Firmware 1.37 - 09/2006 567
9400 HighLine | Parameter setting & configuration
Parameter reference
Parameter list | C00275
C00275
C00276
C00280
C00308
C00309
C00310
C00311
Parameter | Name:
C00275 | Signal source - speed setpoint
Data type: UNSIGNED_16
Index: 24300
d
= 5EEC
h
Selection list (Lenze setting printed in bold)
0 SpeedAdd signal
1 Differentiated PosSet signal
; Read access ; Write access CINH PLC STOP No transfer COM MOT
Parameter | Name:
C00276 | Signal source - torque setpoint
Data type: UNSIGNED_16
Index: 24299
d
= 5EEB
h
Selection list (Lenze setting printed in bold)
0 TorqueAdd/AccAdd signal
1 Differentiated SpeedSet signal
22x diff. PosSet signal
; Read access ; Write access CINH PLC STOP No transfer COM MOT
Parameter | Name:
C00280 | Filter time const. DC detection
Data type: UNSIGNED_32
Index: 24295
d
= 5EE7
h
Setting range (min. value | unit | max. value) Lenze setting
1.0 ms 1000.0 25.0 ms
; Read access ; Write access CINH PLC STOP No transfer COM MOT Scaling factor: 10
Parameter | Name:
C00308 | Service code
Data type: UNSIGNED_16
Index: 24267
d
= 5ECB
h
This code is used internally by the controller and must not be overwritten by the user!
Parameter | Name:
C00309 | Service code
Data type: UNSIGNED_32
Index: 24266
d
= 5ECA
h
This code is used internally by the controller and must not be overwritten by the user!
Parameter | Name:
C00310 | Service code
Data type: UNSIGNED_8
Index: 24265
d
= 5EC9
h
This code is used internally by the controller and must not be overwritten by the user!
Parameter | Name:
C00311 | CAN TPDO1 mask byte x
Data type: BITFIELD_8
Index: 24264
d
= 5EC8
h
A mask can be parameterised for each byte of the TPDO1 in the assigned subcode.
In case of an event-controlled PDO transmission, only the masked bits will be considered for event control.
Mask "0x0" means that no bit of the corresponding byte activates PDO transmission.
Mask "0xff" means that each bit of the corresponding byte can activate PDO transmission.
Value is bit-coded:
Bit 0 Mask bit 0
... ...
Bit 7 Mask bit 7
Subcodes Lenze setting Information
C00311/1 0x00 Mask for byte 1 ... byte 8 of TPDO1
C00311/...
C00311/8
; Read access ; Write access CINH PLC STOP No transfer COM MOT
Vista de pagina 566
1 2 ... 562 563 564 565 566 567 568 569 570 571 572 ... 678 679

Comentarios a estos manuales

Sin comentarios