
9400 HighLine | Parameter setting & configuration
Diagnostics & error analysis
Error messages of the operating system
460 Firmware 1.37 - 09/2006 L
Application has been stopped [0x006a000e]
Breakpoint has been reached [0x006a000f]
Faulty application parameter [0x006a0010]
Division by zero [0x006a0011]
Pointer access in impermissible memory area [0x006a0012]
Application has been started [0x006a0013]
Response (Lenze setting printed in bold)
None System fault Fault Trouble Quick stop by trouble Warning locked Warning : Information
Cause Remedy
The application has been stopped using the device
command C00002
="32". All user tasks are stopped.
Restart application with controller command
C00002="31".
Response (Lenze setting printed in bold)
None System fault Fault Trouble Quick stop by trouble Warning locked Warning : Information
Cause Remedy
The application has reached a set breakpoint and the
user task with the breakpoint has stopped.
Delete breakpoint and restart application.
Response (Lenze setting printed in bold)
None System fault : Fault Trouble Quick stop by trouble Warning locked Warning Information
Cause Remedy
An invalid parameter description has occurred. Transmit application and parameter set to the controller
again.
Response (Lenze setting printed in bold)
None System fault : Fault Trouble Quick stop by trouble Warning locked Warning Information
Cause Remedy
A forbidden division by zero occurred in the application.
The division has been intercepted and the divisor has
been replaced by the value "1".
Exchange application.
Response (Lenze setting printed in bold)
None System fault : Fault Trouble Quick stop by trouble Warning locked Warning Information
Cause Remedy
An invalid pointer access to a protected area occurred in
the application.
Exchange application.
Response (Lenze setting printed in bold)
None System fault Fault Trouble Quick stop by trouble Warning locked Warning : Information
Cause Remedy
The application in the controller has been started. - (Information only)
Comentarios a estos manuales