
L Firmware 1.37 - 09/2006 339
9400 HighLine | Parameter setting & configuration
TAs for interconnection via electrical shaft
TA "Synchronism with mark synchronisation" | Machine parameters
O Tip!
Setting the cycle (C03938) only is required if the selection "Modulo" is set as
traversing range (C02528).
For operation with a virtual master the following setting of the gearbox ratio is
recommended to achieve a good resolution of the guiding angle/master value:
• Numerator (C03930) = 100
• Denominator (C03931) = 1
12.3.3.2 Slave axis (machine axis)
Among other things, the following machine parameters describe the motor end of the
mechanics used.
r Parameter setting: Tab Application parameter Dialog level Overview Synchronism
Machine parameters
O Tip!
Detailed information for selecting and entering the machine parameters for the
machine axis can be found in the chapter "Drive interface
Machine parameters (C 35)
Parameters Lenze setting
Value Unit
C00173 Mains - voltage 400/415 V
C00174
Threshold undervoltage (LU) 285 V
C00600
Resp. to DC bus overvoltage Trouble
C02520
Gearbox fact. numer. motor 1
C02521
Gearbox fact. denom. motor 1
C02527
Motor mounting direction Motor rotating CW
C02570
Controller configuration Position control
C02522
Gearbox fact. numer. load 1
C02523
Gearbox fact. denom. load 1
C02529
Mounting direction of position encoder Encoder rotating CW
Description of the mechanics (load, tool)
C02528
Traversing range Modulo
C02524
Feed constant 360.0000 Unit
C02525
Unit °
C02526
User-defined unit °
C02533 Time unit s
C00273/1 Motor moment of inertia Motor-dependent kg cm
2
C00273/2 Load moment of inertia 0.00 kg cm
2
Comentarios a estos manuales