Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37 Manual de usuario Pagina 391

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 679
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 390
L Firmware 1.37 - 09/2006 391
9400 HighLine | Parameter setting & configuration
TAs for positioning tasks
TA "Multi-purpose positioning" | Profile data management
Icon Profile parameters
(Standard) profile
Profile data set (profile no. 1 ... 100) in which the profile data are stored.
Mode
Selection of the positioning mode. Positioning modes
(C 395)
Position
Target position or path distance to be traversed.
The position is either indicated as absolute or relative position.
An absolute position always specifies the distance to the zero position defined:
absolute position = target position
A relative position indicates the distance to the starting position (current position):
Relative position = target position - starting position
Speed
Maximum speed with which the target is to be approached.
Depending on the profile parameter position, acceleration and deceleration, it is possible that the
drive may not reach the maximum speed. In this case, the graph would display a triangle instead of
a trapezium.
n Acceleration
o Travelling speed (is not reached here)
pDeceleration
q Target position (or feed distance)
Acceleration
Selection of the change in speed by which acceleration is to be carried out maximally.
The following two acceleration types are distinguished:
Constant acceleration: the speed increases linearly.
Linearly increasing acceleration: The speed increases in S-shapes.
n Constant acceleration
o Linearly increasing acceleration
Deceleration
Selection of the change in speed by means of which decleration to standstill is to be maximally effected
again.
A
10 20 30 40 50 60 70 80 90 100
10
30
80
P1
P2
P3
0
10 20 30 40 50 60 70 80 90 100
10
20 50
P3P2P1
0
B
v
pos
v [m/s]
t [s]
C
v
pos
v
pos
v [m/s]
v [m/s]
t [s]
t [s]
D
Vista de pagina 390
1 2 ... 386 387 388 389 390 391 392 393 394 395 396 ... 678 679

Comentarios a estos manuales

Sin comentarios