
L Firmware 1.37 - 09/2006 49
9400 HighLine | Parameter setting & configuration
Drive interface
Device states
4.5.5 State "Operation"
In this device state the motor follows its setpoint according to the selected basic drive
function.
4.5.6 State "Warning active"
This state can occur parallel to the device states "Device is ready to switch on", "Device is
switched on" and "Operation", if a monitoring is activated, the fault response "Warning"
has been parameterised for.
4.5.7 State "Warning locked active"
This state can occur parallel to the device states "Device is ready to switch on", "Device is
switched on" and "Operation", if a monitoring is activated which the fault response
"Warning locked" has been parameterised for.
LED DRIVE READY LED DRIVE ERROR Display in C00183
OFF 0: Operation
LED DRIVE READY LED DRIVE ERROR Display in C00183
1: Operation/warning active
LED DRIVE READY LED DRIVE ERROR Display in C00183
2: Operation/Warning locked active
Comentarios a estos manuales