Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37 Manual de usuario Pagina 195

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 679
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 194
L Firmware 1.37 - 09/2006 195
9400 HighLine | Parameter setting & configuration
Basic drive functions
Speed follower | System block "LS_SpeedFollower"
9.8.4 System block "LS_SpeedFollower"
The LS_SpeedFollower system block in the function block editor maps the basic function
"Speed follower".
Inputs
Outputs
Identifier
DIS code | data type
Information/possible settings
SF_bEnable
C02695/1 | BOOL
Requesting control via the basic function
TRUE If no other basic function is active, it is changed to the function state
"Speed follower active" and the defined setpoints are accepted.
TRUEÌFALSE If no other basic function takes over the control of the drive, the drive
is brought to standstill, i. e. a changeover from the active function
state "Speed follower active" via the function state "Drive is stopped"
back to the basic state "drive in standstill" is effected.
SF_dnSpeedSet_n
C02694/1 | DINT
Speed setpoint in [%]
100 % Motor reference speed (C00011
)
SF_dnSpeedAdd_s
C02693 | DINT
Additive speed setpoint in [rpm]
Without position control function.
SF_dnAccAdd_x
C02692 | DINT
Motor acceleration
For calculating the acceleration torque (in case of setting C00276
="0").
Specified as speed variation/time in [rpm/s]
SF_dnTorqueAdd_n
C02694/2 | DINT
Additive torque precontrol value in [%]
100 % torque at maximum current (C00057/2
).
Identifier
DIS code | data type
Value/meaning
SF_bEnabled
C02695/2 | BOOL
Status output "Basic function is enabled"
TRUE The defined setpoints are accepted.
LS_SpeedFollower
SF_bEnable
SF_dnSpeedSet_n
SF_dnSpeedAdd_s
SF_dnTorqueAdd_n
SF_bEnabled
M
Speed
setpoint
SF_dnAccAdd_x
Vista de pagina 194
1 2 ... 190 191 192 193 194 195 196 197 198 199 200 ... 678 679

Comentarios a estos manuales

Sin comentarios