
L Firmware 1.37 - 09/2006 497
9400 HighLine | Parameter setting & configuration
Diagnostics & error analysis
Error messages of the operating system
Code number assigned twice [0x00900008]
Parameter set: Variant conflict [0x00900009]
No parameters for module in MXI1 [0x0090000a]
No parameters for module in MXI2 [0x0090000b]
Mains voltage switched on [0x00910000]
Mains voltage switched off [0x00910001]
Response (Lenze setting printed in bold)
None System fault Fault Trouble Quick stop by trouble : Warning locked Warning Information
Cause Remedy
Code number of the operating system has been assigned
to the application.
Remove error in the application and retransmit the
application to the controller.
Response (Lenze setting printed in bold)
None System fault Fault Trouble Quick stop by trouble Warning locked Warning : Information
Cause Remedy
The firmware has loaded a parameter set the type code
of which does not comply with the type code of the
controller.
Load a suitable parameter set.
Response (Lenze setting printed in bold) Setting: C00615/2 (; Adjustable response)
; None System fault : Fault ; Trouble ; Quick stop by trouble ; Warning locked ; Warning ; Information
Cause Remedy
The parameter set contains no parameters for the
module inserted in MXI1.
Integrate the module inserted in MXI1 into the Engineer
project and then retransmit the parameter set to the
controller.
Response (Lenze setting printed in bold) Setting: C00615/3 (; Adjustable response)
; None System fault : Fault ; Trouble ; Quick stop by trouble ; Warning locked ; Warning ; Information
Cause Remedy
The parameter set contains no parameters for the
module inserted in MXI2.
Integrate the module inserted in MXI2 into the Engineer
project and then retransmit the parameter set to the
controller.
Response (Lenze setting printed in bold)
None System fault Fault Trouble Quick stop by trouble Warning locked Warning : Information
Cause Remedy
Mains voltage has been switched on. - (Information only)
Response (Lenze setting printed in bold)
None System fault Fault Trouble Quick stop by trouble Warning locked Warning : Information
Cause Remedy
Mains voltage has been switched off. - (Information only)
Comentarios a estos manuales