
L Firmware 1.37 - 09/2006 39
9400 HighLine | Parameter setting & configuration
Drive interface
Parameter setting
4.2.1.5 Unit/application unit
Using these machine parameters you define the real unit of the machine in which the feed
constant and the parameters for a travel profile must be specified (e.g. position, speed,
acceleration, and deceleration).
r If you set, for instance, the "mm" unit for a linear axis, the position must be specified in
[mm] and the speed in [mm/s].
r By means of the freely definable "application unit" the significant production units as
e.g. "bottles" can be set.
– For this, select the entry "User-defined" as unit in C02525
and enter the desired
application unit in C02526
.
Display parameters
Note!
In this documentation, the term "unit" in the parameter unit data only serves as
a wildcard for the real unit of a machine.
Parameters Information
C02533 Time unit
C02534 User-defined time unit
C02535 User-defined unit
C02537 Unit of speed
C02538 Unit of acceleration
Highlighted in grey = display parameter
Comentarios a estos manuales