
L Firmware 1.37 - 09/2006 169
9400 HighLine | Parameter setting & configuration
Basic drive functions
Homing | Parameter setting
9.5.1.2 Home position & target position
When the home position is set during the reference search, the position detected in the
machine measuring system corresponds to the value set in C02642
.
Afterwards the drive travels to the target position set in C02643
.
Operation of mode 14:
1. Movement in positive direction with reduced
torque.
2. The reference is set if the torque limit has
been exceeded via a defined period of time
("homing to end stop").
– If a reference offset is set, it is traversed by
this offset with the correct sign and the
reference is set at the end of this travel
way.
Operation of mode 15:
1. Movement in negative direction with
reduced torque.
2. The reference is set if the torque limit has
been exceeded via a defined period of time
("homing to end stop").
– If a reference offset is set, it is traversed by
this offset with the correct sign and the
reference is set at the end of this travel
way.
Reference position
Reference position
Comentarios a estos manuales