Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37 Manual de usuario Pagina 472

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 679
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 471
9400 HighLine | Parameter setting & configuration
Diagnostics & error analysis
Error messages of the operating system
472 Firmware 1.37 - 09/2006 L
Motor: Calculated leakage inductance unrealistic [0x007b0019]
Absolute value encoder: Communication error [0x007b001a]
Encoder: Open circuit [0x007b001b]
Brake chopper: Ixt overload [0x007b001c]
Brake resistor: I²xt overload [0x007b001d]
Motor: Actual current value > C00620 [0x007b001e]
Response (Lenze setting printed in bold)
None System fault Fault Trouble Quick stop by trouble Warning locked Warning : Information
Cause Remedy
Faulty motor parameterisation. Check motor parameters.
Response (Lenze setting printed in bold)
None System fault : Fault Trouble Quick stop by trouble Warning locked Warning Information
Cause Remedy
Absolute value encoder does not send any data. Check supply cable.
•Check encoder.
Check voltage supply (C00421
).
Response (Lenze setting printed in bold)
None System fault Fault Trouble Quick stop by trouble Warning locked Warning Information
Cause Remedy
Encoder cable interrupted.
Encoder defective.
Faulty parameter setting of the encoder.
Check encoder cable.
•Check encoder.
Check parameter setting (C00422
).
Switch off monitoring, if necessary (C00580
="3").
Response (Lenze setting printed in bold)
None System fault Fault Trouble Quick stop by trouble Warning locked Warning : Information
Cause Remedy
Too frequent and too long brake operations. Check drive dimensioning.
Response (Lenze setting printed in bold)
None System fault Fault Trouble Quick stop by trouble Warning locked Warning : Information
Cause Remedy
Too frequent and too long brake operations. Check drive dimensioning.
Check parameter setting (C00129
, C00130, C00131,
C00132
).
Response (Lenze setting printed in bold) Setting: C00619 (; Adjustable response)
; None System fault : Fault ; Trouble ; Quick stop by trouble ; Warning locked ; Warning Information
Cause Remedy
The instantaneous value of the motor current has
exceeded the value set in C00620
.
Set a higher value in C00620
.
Reduce maximum current (C00022
).
Change response (C00619
).
Vista de pagina 471
1 2 ... 467 468 469 470 471 472 473 474 475 476 477 ... 678 679

Comentarios a estos manuales

Sin comentarios