Lenze ETC Motion Control Manual de usuario descargar pdf (Pagina 83)

100

101

Getting started

Updating the firmware of the ETCHx in the "Standalone" operating mode

Calling the boot monitor in the control system

2.16

2.16.1

EDSTCXN EN 2.0

2.16 Updating the firmware of the ETCHx in the "Standalone" operating mode

) Note!

The steps described in this chapter only apply to the ETCHx

variant (DIN rail variant); they are not required for the ETCPx

variant (PCI card).

2.16.1 Calling the boot monitor in the control system

Initial state: The communication between PC and ETCHx has been

established and the monitor interface activated (¶ 21)

1. In the terminal program, enter the command reboot.

2. During the running reboot process, press and hold the <Shift> + <!>

keys.

ETCM012

When the prompt ">" appears, the input in the boot monitor of the

control system is active. On the control system, the LEDs 1 ... 6 flash

circulatingly.

) Note!

When the firmware is running, the control system can also be

reset by switching the control system on/off or by pressing the

reset key.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 427 428

Comentarios a estos manuales

ama 11 Jan 2025 | 19:35:39

rasha

Lenze ETC Motion Control Manual de usuario Pagina 83

Comentarios a estos manuales

Relacionado con productos y manuales para Software Lenze ETC Motion Control