Lenze ETC Motion Control Manual de usuario descargar pdf (Pagina 296)

ETC−MMI

"Setup" operating mode

7.4

296

EDSTCXN EN 2.0

ETCN070

Import + save The data from the table is transferred to the NC

computer and saved on the PC in a file.

back... Back to the previous level.

Load tool record Open a dialogue for selecting a file with tool data (WTK

file). This file will be transferred to the control system.

Tool number In the upper edge of the "Status displays" dialogue

there is a field for entering a tool number (Tx). After the

key has been pressed, the field has a coloured

background and the cursor flashes in this field. A tool

number can be entered here. Changes are adopted with

<Enter> and discarded with <ESC>.

back... Back to the previous level.

Enter M function In the upper edge of the "Status displays" dialogue

there is a field for entering an M function. After the key

has been pressed, the field has a coloured background

and the cursor flashes in this field. A function number

can be entered here. Changes are adopted with <Enter>

and discarded with <ESC>.The M function is transferred

to the PLC for execution.

Entry Enter single block (e.g. G, S, T and M functions). The

execution is completed and triggered with <Enter>.

Start Trigger action (e.g. automatic home position approach).

Stop Quit all axis movements and a running program.

Travel+ Manual traverse key for positive axis direction of the

selected axis.

Travel− Manual traverse key for negative axis direction of the

selected axis.

Axis Select the axis to be traversed. Alternatively, the axis

can be selected by means of the <Cursor> keys.

Override+ Increase the axis or path speed of the selected axis (in

percent of MK_VMAX). Over 10%, the value is changed

in steps of 10%, below 10% in steps of 1%.

Override− Reduce the axis or path speed of the selected axis (in

percent of MK_VMAX). Over 10%, the value is changed

in steps of 10%, below 10% in steps of 1%.

Vertical function keys

1 2 ... 291 292 293 294 295 296 297 298 299 300 301 ... 427 428

Comentarios a estos manuales

ama 11 Jan 2025 | 19:35:39

rasha

Lenze ETC Motion Control Manual de usuario Pagina 296

Comentarios a estos manuales

Relacionado con productos y manuales para Software Lenze ETC Motion Control