Lenze ETC Motion Control Manual de usuario descargar pdf (Pagina 267)

100

101

Interface PLC <˘> NC operating system

Definitions

Data block 1

5.1

5.1.2

267

EDSTCXN EN 2.0

Data word Name Direction Type of signal

192.00−199.15 State CAN modules (CANopen) NC → PLC static

Signal state "1" indicates that the corresponding CANopen module is availa-

ble. The bits in the data words are assigned by means of the module ID (node

no.).

Example:

192.01 indicates state of node 1

192.15 indicates state of node 15

193.01 indicates state of node 17

Effect in the PLC: Option of monitoring the CAN modules.

Data word Name Direction Type of signal

200 General override for axes NC → PLC static

201 Override for spindle speed NC → PLC static

202 Override for oscillation speed NC → PLC static

203 Override for PLC axes (Target

position approach)

NC → PLC static

Evaluation factor which is set on the HMI for the currently valid traversing

speed. The specification is made in steps of 0.1 % (copy from the virtual key-

board).

Effect in the NC: The selected value is used as a factor for evaluating the cur-

rently programmed maximum speed of the rough interpolator. The override

is effective both in manual as well as in automatic operation. It can be inhibi-

ted, for example, by M functions within a program.

Data word Name Direction Type of signal

204.00−07 Traverse key axis 0 HMI → PLC static

204.08−15 Traverse key axis 1 HMI → PLC static

... ... ... ...

... ... ... ....

212.00−07 Traverse key axis 14 HMI → PLC static

212.08−15 Traverse key axis 15 HMI → PLC static

Like description for DW 84−91. Only significant if traverse key enable of the

PLC is activated and if traverse keys are available for the MMI.

1 2 ... 262 263 264 265 266 267 268 269 270 271 272 ... 427 428

Comentarios a estos manuales

ama 11 Jan 2025 | 19:35:39

rasha

Lenze ETC Motion Control Manual de usuario Pagina 267

Comentarios a estos manuales

Relacionado con productos y manuales para Software Lenze ETC Motion Control