Lenze ETC Motion Control Manual de usuario descargar pdf (Pagina 43)

100

101

Getting started

Parameterising drives via machine constants

Checking the parameters of the drives

2.8

2.8.6

EDSTCXN EN 2.0

) Note!

Basically, the operation of the CNC program is also possible:

ƒ without connected mechanics and drives.

This is achieved by setting the machine constant

MK_TEST_OHNEMECHANIK=1.

ƒ without a PLC program.

This is achieved by setting the machine constant

MK_SPS_DUMMY=1.

For the following tests with mechanics, the above−mentioned machine

constants must be set as follows:

MC keyword No. of

values

Values

MK_TEST_OHNEMECHANIK 1 0

MK_SPS_DUMMY 1 1

2.8.6 Checking the parameters of the drives

After the machine constants have been adapted, the connected drives can

be checked via their tolerance margin in the diagnostics.

1. In the ETC MMI window, press <F12> (diagnostics).

The MMI window opens in the "Diagnostics" operating mode.

ETCN012

Correctly parameterised drives show an alternating tolerance margin

around the zero point.

Test setting

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 427 428

Comentarios a estos manuales

ama 11 Jan 2025 | 19:35:39

rasha

Lenze ETC Motion Control Manual de usuario Pagina 43

Comentarios a estos manuales

Relacionado con productos y manuales para Software Lenze ETC Motion Control