Lenze ETC Motion Control Manual de usuario descargar pdf (Pagina 260)

100

101

Interface PLC <˘> NC operating system

Definitions

Data block 1

5.1

5.1.2

260

EDSTCXN EN 2.0

Data word Name Direction Type of signal

132.02 Block search active NC → PLC static

Value "1" of the signal indicates that the processing of an NC program is ac-

tive in the block search. The signal is pending until the target block of the

block search has been reached.

Data word Name Direction Type of signal

132.03 Individual block is running NC → PLC static

Value "1" of the signal indicates that the processing of an individual block is

active, triggered by the individual block function (see ETC MMI) or by input

on the MMI (manual operation). The signal is pending until block termina-

tion ("NC program stop") or internal termination due to an error which can-

not be remedied.

Effect in the PLC: Evaluation for disable, synchronization, time measure-

ment.

Data word Name Direction Type of signal

0132.04 Interrupt active PLC → NC static

Value "1" of the signal indicates that the NC is in the "Interrupt" state

(see also "Interrupt" signal).

Effect in the PLC: None.

Data word Name Direction Type of signal

132.08 All axes stopped NC → PLC static

The signal always has value "1" when the axes have stopped or no command

for traversing the axis is currently active.

The signal "All axes stopped" is generated from the state signals of all axes.

Data word Name Direction Type of signal

133.00−07 Optional hold NC → PLC static

This signal from the MMI activates a "Programmed hold" through M01.

Effect in the NC:

0 = optional hold inactive

1 = optional hold active

1 2 ... 255 256 257 258 259 260 261 262 263 264 265 ... 427 428

Comentarios a estos manuales

ama 11 Jan 2025 | 19:35:39

rasha

Lenze ETC Motion Control Manual de usuario Pagina 260

Comentarios a estos manuales

Relacionado con productos y manuales para Software Lenze ETC Motion Control