Lenze ETC Motion Control Manual de usuario descargar pdf (Pagina 21)

100

101

Getting started

Establishing the communication between PC and ETCHx

Starting ETCHx

2.4

2.4.1

EDSTCXN EN 2.0

2.4 Establishing the communication between PC and ETCHx

) Note!

The steps described in this chapter only apply to the ETCHx

variant (DIN rail variant); they are not required for the ETCPx

variant (PCI card).

2.4.1 Starting ETCHx

1. Connect the serial interfaces of PC and ETCHx.

For this purpose, use the system cable of type EWL 0068 or a comparable

RS232 cable with double−sided 9−pin D−Sub socket (for the pin

assignment see ETC Hardware Manual).

2. Start the PC.

3. Start the ETCHx by mains connection or initialise the ETCHx by a reset

(press the Reset key on the front panel).

As soon as the ETC firmware has been loaded, the green watchdog LED

lights up at the ETCHx .

2.4.2 Starting the terminal program "HyperTerminal" and activating the monitor interface

For the communication between PC and ETCHx, you require a terminal

program. The terminal program "HyperTerminal" is available in every

standard Windows installation.

1. If you have already established a connection with an ETC (i.e. if a

connection is already configured), start the connection via <Start>

Programs W Accessories W Communication W HyperTerminal W

ConnectionName.ht. See next section.

If no connection has been configured yet, start the HyperTerminal via

<Start>

W Programs W Accessories W Communication W HyperTerminal.

The program queries different settings of the telephone connection

because it is also designed for a modem connection. These settings are

not significant in this context.

2. After you have been prompted, enter a name for the connection (for

example "ETC") and click OK.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 427 428

Comentarios a estos manuales

ama 11 Jan 2025 | 19:35:39

rasha

Lenze ETC Motion Control Manual de usuario Pagina 21

Comentarios a estos manuales

Relacionado con productos y manuales para Software Lenze ETC Motion Control