Lenze ETC Motion Control Manual de usuario descargar pdf (Pagina 274)

Interface PLC <˘> NC operating system

Extended interface for MMI functions

Data block 15

5.2

5.2.2

274

EDSTCXN EN 2.0

Data word Name Direction Type of signal

028.00−07 Traverse key axis 0 HMI → NC static

028.08−15 Traverse key axis 1 HMI → NC static

029.00−07 Traverse key axis 2 HMI → NC static

029.08−15 Traverse key axis 3 HMI → NC static

030.00−07 Traverse key axis 4 HMI → NC static

030.08−15 Traverse key axis 5 HMI → NC static

031.00−07 Traverse key axis 6 HMI → NC static

031.08−15 Traverse key axis 7 HMI → NC static

032.00−07 Traverse key axis 8 HMI → NC static

032.08−15 Traverse key axis 9 HMI → NC static

033.00−07 Traverse key axis 10 HMI → NC static

033.08−15 Traverse key axis 11 HMI → NC static

These signals are used for traversing the axes. One byte is available for each

axis. By writing the bytes, the respective action is carried out.

Effect in the NC:

−100 to +100: traversing with % of the maximum speed. The sign defines the

direction.

+/−101: inching by increment (corresponds to DW44 ... 47) on the path if

there is no feed enable. Only available in the case of a programmed traver-

sing movement.

+/−102: home position approach (sign is ignored).

+/−103: setting zero point (sign is ignored)

+/−104: step travel.

+/−105: handwheel active − evaluation factor 1.

+/−106: handwheel active − evaluation factor 3.

+/−107: handwheel active − evaluation factor 10.

+/−108: handwheel active − evaluation factor 30.

+/−109: handwheel active − evaluation factor 100.

+/−110: traverse command for PLC axis

+/−111: traversing with the speed from P208 ... 223.

The sign defines the direction. (¶ 136).

1 2 ... 269 270 271 272 273 274 275 276 277 278 279 ... 427 428

ama 11 Jan 2025 | 19:35:39

rasha

Lenze ETC Motion Control Manual de usuario Pagina 274