Lenze ETC Motion Control Manual de usuario Pagina 27

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 428
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 26
Getting started
Establishing the communication between PC and ETCHx
Setting the operating mode of the ETCHx
2
2.4
2.4.3
l
27
EDSTCXN EN 2.0
After loading is complete, the following figure is displayed:
ETCN007
The control system waits until the firmware is loaded from the PC; on the
ETC front plate, the LEDs 1 ... 6 flash circulatingly.
5. In the HyperTerminal window, enter quit and confirm the command
with <Enter> .
The firmware starts. On the ETC front plate, the green watchdog LED
lights up.
Vista de pagina 26
1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 427 428

Comentarios a estos manuales

ama 11 Jan 2025 | 19:35:39

rasha