Lenze ETC Motion Control Manual de usuario descargar pdf (Pagina 35)

100

101

Getting started

Starting ETC−MMI

Establishing a connection between ETC−MMI and ETC

2.7

2.7.2

EDSTCXN EN 2.0

3. To create a new connection, click on Add on the "Connection" tab.

ETCN004

4. Specify a name for the connection.

To enable an application to communicate with a control system via the

ETC−MMI Gateway, each connection must be assigned an unambiguous

name. You can choose any name. Assign e.g. consistent names "ETC0",

"ETC1" ... or application−specific names "ramp", "laser control" etc. A

name can contain up to 31 ASCII characters ("A ... Z", "a ... z" , "0 ... 9").

5. Select a connection type:

ƒ UDP connection for ETCHx control systems

Ethernet communication via DPR/UDP/IP protocol.

ƒ PCI connection for ETCPx control systems

DPR communication via a WDM driver (ETCPC.sys, in the scope of supply

of the ETCPC).

6. Enter a communication parameter in the "IP address" field:

ƒ ETCHC = IP address (¶ 28)

ƒ ETCPC = Index of the PCI cards (indexes of the PCI cards are in the range

0 ... 9 and are automatically assigned by the driver. The first ETCPx has

the index 0).

7. Close the dialogue via OK.

Your entries are saved in the file "mmigtway.ini" (¶ 283). If a connection

with the same parameters already exists, the error "Gateway cannot

change the parameter" is reported.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 427 428

Comentarios a estos manuales

ama 11 Jan 2025 | 19:35:39

rasha

Lenze ETC Motion Control Manual de usuario Pagina 35

Comentarios a estos manuales

Relacionado con productos y manuales para Software Lenze ETC Motion Control