Lenze ETC Motion Control Manual de usuario descargar pdf (Pagina 286)

100

101

ETC−MMI

Installing ETC−MMI

7.1

286

EDSTCXN EN 2.0

7 ETC−MMI

The program "ETC−MMI" is used for the following tasks:

ƒ Configuring the control system

ƒ Operating and monitoring the control system

ƒ Maintenance of the control system and error diagnosis

7.1 Installing ETC−MMI

( Stop!

Only install the PCI control variant ETCPx after installing the

ETC−MMI and before starting the ETC−MMIs.

) Note!

The ETC−MMI Gateway is installed during the installation of the

Lenze ETC−MMIs

1. In Windows File Explorer, open the program "setup.exe" on the

ETC−MMI installation CD.

2. Follow the instructions of the installation program. The following will

be requested:

– Demo or standard installation

– Control type (ETCHC or ETCPC)

– IP address of the ETCHC (¶ 28) or index of the ETCPC (indexes of the

PCI cards are in the range 0 ... 9 and are automatically assigned by the

driver. The first ETCPx has the index 0).

In the start bar, the entry "Lenze ETC−MMI" is created. It can be used to

start the application.

3. For an ETCHC: Check that the TCP/IP protocols are installed in the

network properties (Start

W Settings W Control Panel W Network).

For an ETCPC: Install the ETCPC plug−in card in the PC. Observe the notes

in the ETC Hardware Manual.

1 2 ... 281 282 283 284 285 286 287 288 289 290 291 ... 427 428

Comentarios a estos manuales

ama 11 Jan 2025 | 19:35:39

rasha

Lenze ETC Motion Control Manual de usuario Pagina 286

Comentarios a estos manuales

Relacionado con productos y manuales para Software Lenze ETC Motion Control