Lenze ETC Motion Control Manual de usuario descargar pdf (Pagina 335)

100

101

ETC−MMI

Appendix

Configuration file (DELPHMMI.INI)

7.8

7.8.3

335

EDSTCXN EN 2.0

The configuration of the bar displays for Vist and Override can be changed

to display a different value from the DPR. Moreover, two different bar

displays below the axis positions can be configured in the Automatic

operating mode.

For this purpose, there is a new section [BarAnz] in the Delphmmi.ini. This

section contains up to four entries for the four bars.

Example:

[BARANZ]

ANZ1=0;800;10802;1;P30

ANZ2=0;800;10902;2;P31

ANZ3=0;3000;10920;3;4711;DOUBLE

Anz4=0;4000;10930;4;D10,WORD

The values of an entry have the following meaning:

1. Min value of the bar or the labelling (currently, the entries < 0 are not

supported)

2. Max value of the bar or the labelling (the Max value must be greater

than the Min value)

3. Text number of the descriptive text in the language text

4. Bar on which the value is to be displayed:

1= upper right (standard Vist)

2= lower right (standard Override)

3= upper left (standard invisible)

4= lower left (standard invisible)

5. The value to be displayed; there are three types of specifying a value:

PXX: Index on the field permanent display; the corresponding field must

be entered in the Delphmmi.ini in for the corresponding displays.

DXX: PLC DB2 display off 0 ... 63,

XXXX: Direct address in the DPR

6. If the information on the displayed value is specified via DB2 or via a

direct address, the value format must also be specified. The following

values are permitted:

BYTE

DOUBLE

INTEGER

LONG

SINGLE

WORD

For P fields the data type is always double.

BARANZ

1 2 ... 330 331 332 333 334 335 336 337 338 339 340 ... 427 428

Comentarios a estos manuales

ama 11 Jan 2025 | 19:35:39

rasha

Lenze ETC Motion Control Manual de usuario Pagina 335

Comentarios a estos manuales

Relacionado con productos y manuales para Software Lenze ETC Motion Control