Lenze ETC Motion Control Manual de usuario descargar pdf (Pagina 20)

100

101

Getting started

Commissioning steps (overview)

2.3

EDSTCXN EN 2.0

2.3 Commissioning steps (overview)

( Stop!

Observe the notes in the chapter "Initital switch−on" of the ETC

Hardware Manual before commissioning the system.

) Note!

Only build in and install the PCI control variant ETCPx in step 6.

Step ETCHC ETCPC Description See

1X− Connect ETCHC via RS232 cable with PC and start ETCHC. ^ 21

2 X − Start terminal program on the PC (if required, configure in

advance) and activate monitor interface of the ETCHC.

^ 21

3 X − If the ETCHC is to be operated in the "with MMI"

operating mode, replace the firmware file on the ETC by

the file "NetBoot.rsc".

^ 25

4 X − Assign the IP address of the ETCHC. ^ 28

5 X X If required, install ETC−MMI and ETC−MMI Gateway. ^ 31

6 − X Install ETCPC in the PC and install the driver. ^ 31

7 X X Start ETC−MMI and ETC−MMI Gateway. ^ 32

8 X X Establish connection between ETC−MMI and ETCxC. ^ 34

9 X X Parameterise drives via machine constants. ^ 36

10 X X Check parameters of the drives. ^ 43

11 X X Test drives in inching mode. ^ 44

12 X X Create CNC program in the ETC−MMI. ^ 47

13 X X Load CNC program into ETCxC, start and test CNC

program.

^ 49

14 X X If required, install CoDeSys. ^ 51

15 X X Start and configure CoDeSys. ^ 51

16 X X Create PLC program. ^ 60

17 X X Load PLC program into ETCxC, start and test PLC program. ^ 68

18 X X Test CNC and PLC program. ^ 72

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 427 428

Comentarios a estos manuales

ama 11 Jan 2025 | 19:35:39

rasha

Lenze ETC Motion Control Manual de usuario Pagina 20

Comentarios a estos manuales

Relacionado con productos y manuales para Software Lenze ETC Motion Control