Lenze ETC Motion Control Manual de usuario descargar pdf (Pagina 60)

100

101

Getting started

Creating a PLC sample program

Required hardware

2.12

2.12.1

EDSTCXN EN 2.0

2.12 Creating a PLC sample program

This chapter describes the creation of a PLC program using an ETCHx system

as example. Please note the differences in the case of an ETCPx system.

2.12.1 Required hardware

24V0V

Ethernet

ETCN003

ETCHM004

I_ToolDown

I_ToolUp

O_ToolDown

I_NoEStop

ETCHI008

ETCHU008

ETCHT000

ETCM015

ƒ The 24 V voltage is connected to the modules ETCHN003 (power supply

unit) and ETCHU008 (output module).

ƒ A switch Tool down (I_ToolDown) is connected at the input IN3 of the

ETCHI008.

ƒ A switch Tool up (I_ToolUp) is connected at the input IN4 of the

ETCHI008.

ƒ A switch Emergency stop (I_NoEStop) is connected at the input IN8 of

the ETCHI008.

ƒ A relay Tool down (O_ToolDown) is connected at the output OUT1 of

the ETCHU008.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 427 428

Comentarios a estos manuales

ama 11 Jan 2025 | 19:35:39

rasha

Lenze ETC Motion Control Manual de usuario Pagina 60

Comentarios a estos manuales

Relacionado con productos y manuales para Software Lenze ETC Motion Control