Lenze ETC Motion Control Manual de usuario descargar pdf (Pagina 130)

100

101

CNC programming

G functions

G functions individual descriptions

3.2

3.2.2

130

EDSTCXN EN 2.0

3.2.2.42 G112 Tangential correction "on"

The tangential correction of the C axis is switched on.

G112 AXES

AXES Validity identification and mode for rotation axis to be corrected. Only one

axis can be specified!

For path profiles with tangential or approximate tangential transitions, an

automatic tangential correction of a rotation axis is possible. For this, there

are two modes, which must be programmed as a numerical value under the

respective axis code letters.

Mode 1: Tangential correction from current position of the rotation axis

(standard)

Mode 2: Tangential correction with abrupt positioning of the rotation axis

at the start of the interpolation task on the angle programmed in the

geometry function

The pure correction only has an effect on circle profiles; the abrupt

positioning has an effect on all interpolation types.

) Note!

This function does not calculate the current path vector in the

case of linear interpolation, i.e. the rotation axis is not aligned

automatically to the current path orientation.

The speed of the correction axis is corrected. The correction takes

place up to the maximum permissible axis speed (MK). If this

speed is exceeded, the path speed is reduced accordingly.

The function has a modal effect and can be deselected by G113.

G112 C1 The tangential correction for the C axis is switched on in normal mode

(pure correction without alignment on programmed angle).

Syntax

Meaning of the addresses

Explanation

Example

1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 427 428

Comentarios a estos manuales

ama 11 Jan 2025 | 19:35:39

rasha

Lenze ETC Motion Control Manual de usuario Pagina 130

Comentarios a estos manuales

Relacionado con productos y manuales para Software Lenze ETC Motion Control