Lenze ETC Motion Control Manual de usuario descargar pdf (Pagina 338)

100

101

PLC programming

Connecting ETC and PC

V.24 Interface

8.3

8.3.1

338

EDSTCXN EN 2.0

8.3 Connecting ETC and PC

The connection to the ETC can be established via one of the following

interfaces:

ƒ Serial interface

ƒ Ethernet interface (only ETCHx, DIN rail design)

ƒ DPR interface (only ETCPx, PCI insert card)

8.3.1 V.24 Interface

For communication via the serial interface the RS232 or CAN2 connection of

the ETC must be connected via a null modem cable to a free COM port of the

PC. The driver "3S Serial RS232 driver" must be selected in the

communication parameters of CoDeSys. In the settings for this driver the

following values must be selected for the corresponding interface of the

control:

ETCconnection RS232 CAN2

Baud rate 115200 38400

Parity No No

Stop bits 1 1

Motorola byte order Yes Yes

8.3.2 Ethernet interface (only ETCHx, DIN rail design)

For Ethernet communication the Ethernet connection at the ETCHx must be

connected to the PC via an Ethernet cable.

The driver "3S Tcp/Ip level2 driver" must be selected in the communication

parameters of CoDeSys. The following values must be entered in the settings

for the driver:

ETC100

1 2 ... 333 334 335 336 337 338 339 340 341 342 343 ... 427 428

Comentarios a estos manuales

ama 11 Jan 2025 | 19:35:39

rasha

Lenze ETC Motion Control Manual de usuario Pagina 338

Comentarios a estos manuales

Relacionado con productos y manuales para Software Lenze ETC Motion Control