Lenze EVS9332xP Manual de usuario descargar pdf (Pagina 114)

Function library

Positioning control

3.4.13 Program sets (PS)

3−86

EDSVS9332P−EXT DE 2.0

3.4.13.8 Prg. fct. Switch output before positioning"

Purpose

Setting or resetting a digital output signal (POS−PFO), for instance, to control a machine function

before positioning starts.

9300pos014

Fig. 3−35 Diagram − Switch output

Function

l Selection of any PFO under C1320/x. It is also possible to switch all PFO at the same time or

in groups of 8.

l Selection of the signal level (setting or resetting) under C1321/x.

l 32 PFO are available (see POS−PFO).

l GDC input: Programming" dialog

l Default setting: not active

3.4.13.9 Prg. fct. Switch output after positioning"

Purpose

Like Switch output before positioning".

Function

l Selection of any PFO under C1322/x. It is also possible to switch all PFO at the same time or

in groups of 8.

l Selection of the signal level (setting or resetting) under C1323/x.

l 32 PFO are available (see POS−PFO).

l GDC input: Programming" dialog

l Default setting: not active

Tip!

If an output is to be set and reset before a positioning process, the output will not be switched if no

positioning has taken place or the target position has been reached in the same cycle. As a remedy

the output can be reset in one of the following PS. The output will then be switched for at least one

cycle.

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 333 334

Sin comentarios

Lenze EVS9332xP Manual de usuario Pagina 114